Types of tambourine
A tambourine is a frame drum with small metal jingles set into its frame. Most are round and handheld, but they differ in some important ways.
- Headed tambourines have a drum head stretched across the frame. You can strike the head for a drum-like sound and also shake the jingles.
- Headless tambourines have no head, and are mainly used to produce jingle sounds.
- Jingles vary in number, size and material, which changes how bright and loud the sound is.
The techniques below work best on a headed tambourine, but most of them also apply to a headless one.
How to hold it
- Hold with your non-dominant hand. Grip the frame lightly with your thumb on one side and fingers on the other, leaving room to let the jingles move. Avoid a tight grip, which dulls the sound.
- Angle it. Many players hold the tambourine at roughly 45 degrees in front of the body, which helps the jingles respond and keeps the head within easy reach of your other hand.
- Keep it at a consistent height, somewhere around chest to waist level, so the sound carries and you can see your timing.
- Stay relaxed. Shoulders low, elbows loose, wrists flexible. Tension makes strokes noisy and uneven.
Shaking
Shaking is the simplest technique and the one most beginners start with.
- Rotate your wrist or forearm slightly to rattle the jingles.
- Keep the movement small and controlled. A big, wild shake is loud and hard to keep in time.
- Aim for a clean rhythm, shaking exactly on the beats you intend, with a clear stop in between.
- To keep the jingles from ringing between shakes, you can touch the frame or the head lightly with a finger to mute them.
Practise shaking on every beat of a bar, then on 2 and 4 only, then on a pattern like 1 and 3, so you learn to control where the sound starts and stops.
Tapping
Tapping uses your free hand to strike the head or frame. It gives a more percussive sound than shaking.
- Fingertip (edge) stroke: gather your fingers and thumb into a point and strike the head near the edge. This gives a light, dry sound with a small jingle response, good for quiet passages.
- Fist (knuckle) stroke: strike the middle of the head with the fist, or the knuckles, for a clear, punchy accent. Keep it relaxed, as a stiff fist can hurt.
- Open hand stroke: hit the head with a flat, open hand for a fuller, louder sound. Avoid slamming too hard, which can hurt your hand and strain the head.
Alternate strokes to create variety, such as a fist stroke on the main beats and a light fingertip tap in between.
The knee-and-hand technique
For faster, louder rhythmic passages, many players use their leg too. Hold the tambourine so the frame or head can strike your knee and your free hand can strike the head, alternating between them.
- The knee stroke is typically the downbeat, and the hand stroke follows.
- Keep your leg relaxed and use the weight of the instrument.
- Practise slowly first, as the motion can feel awkward.
- Stop if it bruises or hurts, and adjust your angle or use a gentler touch.
Different teachers describe this technique in different ways, so follow whichever version you learn, and keep movements small.
Rolls
A roll is a sustained, continuous jingle sound.
Shake roll
Rotate your wrist or forearm back and forth quickly and evenly, holding the tambourine more vertically. The aim is a continuous jingle with no gaps. Start slowly, as a fast roll depends on relaxation and not on force. Practise getting a smooth roll that starts and stops cleanly.
Thumb roll
Rub your thumb (or a fingertip) around the edge of the head with moderate pressure, which makes the jingles vibrate through friction. It produces a softer, shimmering roll. Some players use a small amount of beeswax or rosin on the head to help the thumb grip. If you try this, use only a little, and check that the product suits your tambourine.
Releases
A roll often ends with a short strike, such as a fist or knee stroke, to make a sharp finish. Soft rolls can be stopped by gently touching the jingles. Practise both until you can stop a roll exactly where you intend.
Playing with a band
- Match the dynamics. Play softly in quiet verses and more firmly in choruses. The tambourine is bright, and too much of it can overpower other instruments.
- Support the groove. A steady tambourine on the backbeat (2 and 4) or on eighth notes can reinforce a drummer’s rhythm, as on many Motown records. If you play with a cajon, see cajon beats for beginners for a basic groove that works well with it.
- Leave space. Stopping the jingles at the right moments often sounds better than playing constantly.
- Listen first. Follow the drummer or the song’s pulse and don’t rush.
Practice exercises
- Even shakes: shake on every beat with a metronome at a slow speed for one minute.
- Shake and tap: shake on beats 1 and 3, and fist stroke on 2 and 4.
- Soft to loud: play four bars at a whisper, then four bars firmly, then back again.
- Roll and release: play a two-beat shake roll and end with a clear hit on the next beat.
- Silent practice: you can build coordination without sound by tapping patterns on a tabletop using the ideas in the table drumming tutorial.
Common problems
- Too loud or too busy. Make smaller movements, and leave gaps.
- Muddy jingles. Hold the frame more loosely, so the jingles can ring, and mute them with a finger when you need silence.
- Uneven timing. Count aloud, practise with a metronome and slow down.
- Sore hands or wrists. Reduce force, relax your grip and take breaks. Stop if you feel sharp pain.
- Rolls that break up. Use smaller, faster movements, and don’t tense your arm.
If you want to see where the tambourine fits among other frame drums and hand percussion, the hand drums guide gives a quick overview.